Innovative long-lasting paint protection defined by ultimate hardness of titanium particles
Its maximum efficiency is achieved by applying an activator together with coating.
The coating provides outstanding durability and resistance to chemicals together with providing a great look to the paint.
How to apply the product:
1 Apply few drops of an Activator onto applicator covered with small cloth.
2 Spread the Activator evenly onto the surface.
3 Gently wipe with a microfibre cloth and leave for ~30 minutes
4 Apply thin and even layer of Titanium Coat onto one paintwork section using applicator wrapped with another cloth.
5 Leave the layer on the surface for 5-10 minutes (bonding time).
6 Buff the surface with microfiber towel to a high gloss. Keep the towel gently, do not press it to the paint.
7 Move to next paintwork section. Attention: Do not apply T1 to hot surfaces or in direct sunlight.
It is good to know that:
If you want to know if the product is ready to buff, first try to move a hanging towel over drying coating. If the towel slides easily then wait a few minutes until the surface will start to slow it down.
Do not press the towel while buffing, ’cause it may remove the coat from the surface. Do it gently.
For best results put up to 3 layers of the product with minimum time interval of 3 hours. You need only one layer of Activator.
What you need to know:
1 Use thin rubber protective gloves.
2 Apply indoor only with temperature of 18-24 C.
3 Make sure the car paint is clean and cool.
4 Degrease and remove old coatings from car paint before application.
5 Apply additional layers with minimum time interval of 3 hours.
6 Drying time after application of last layer – 12-24 hours in dry and warm place.